In this weeks video I get the Project 240sx 5.0 v8 swap ready for the new buyer and finally see it drive away. It’s kind of bitter sweet. I never got to finish the project, but at the same time I don’t think I would of got around to finishing it. I just lost interest […]
July 30, 2018
In this video I find out that my 2008 Chevy Silverado wont start. So instead of doing the intended DIY video, I try to diagnose the issues I have with my 2008 Chevy Silverado. After charging the battery, it still didnt start. So I then install a new mega fuse on the power side of […]
May 9, 2018
In this midweek special upload, I work on the 240sx and get it that much closer to starting!! Watch and enjoy!
April 28, 2018
In this weeks video I finally get back to working on my 5.0 v8 swapped 240sx. It’s been a couple of months since I’ve worked on it, so I thought I should probably get back to it. I’ve been slacking like crazy on this project 240sx, so I just need to suck it up and […]
March 18, 2018
In this weeks video the Chevelle gets new wheels! They are the Riddler 650’s. I went with a staggered wheel setup with 18×8 in the front and 18×9.5 in the rear. The tires are 245/40/18 in the front and 275/35/18 in the rear. Putting this new wheel setup on my 1967 Chevelle really changed the […]
February 11, 2018
In this weeks video we’ll be installing a ford 5.0 v8 in my 240sx! If you’ve been following this series you know this has been along time coming. BUT I am really inspired to finally finish this project 240sx build. This video isn’t really a how to install a v8 in a 240sx, but more […]
January 28, 2018
In this weeks video I show you how to install a backup camera in a 2008 Chevy Silverado. This is a cheap, affordable back up camera that I got on Amazon for only $24.99! Not only is it super cheap, but it’s very easy to install too!
January 7, 2018
In this video I show you the steps it takes to convert your 240sx to a hydraulic throw out bearing. The reason fro a hydraulic throw out bearing is because I have a t5 transmission now and it’s normally a cable driven clutch fork, so I had to convert it.
December 17, 2017
In this video I do some engine dress up on the Ford 5.0 motor swap in my 240sx.
November 26, 2017
In this episode I do some garage prep and update everyone on the Nissan 240sx budget build. I remove the t5 transmission from the ford 302 5.0 mustang engine and check it out to make sure its in decent shape.